Digital Equipment VAXstation 2000 Hardware Installation Manual page 107

2. At the console prompt, type TEST 70 and press RETURN.
The following text appears on the monitor screen: —^
KA410-A RDRXfmt
VSfmt_QUE_unitno (0-2) ?
3. Type the number 0 to format a fixed disk drive in the system unit. Type
the number 1 to format a fixed disk drive in the expansion box.
If everything is working normally, the following text is displayed:
VSfmt_STS_Siz
If you have typed an incorrect number, the following text is displayed:
VSfmt.RES.ERR #1
If an error message occurs, start over at the first step of the formatting
procedure. If you continue to see the error message, refer to the
VAXstation 2000 Owner's Manual, Chapter 2 (Troubleshooting), for
information on isolating and solving problems.
If the formatter is working successfully, you will see the following text
displayed as the formatter program determines the type of fixed disk drive
you have selected for formatting. In the following example, the RD32 is
the disk being formatted.
VSfmt.STS.Siz RD32
If you see the following error messages:
VSfmt.STS.Siz ??
or
VSfmt_RES_Err # 2
84 FAIL
» >
there is a problem with the fixed disk drive. Refer to the VAXstation
2000 Owner's Manual, Chapter 2 (Troubleshooting), for information on
isolating and solving problems. If the drive is formatting properly, the
following is displayed:
VSfmt_QUE_SerNbr (0-999999999) ?
4. Type in the serial number of the fixed disk and press RETURN. The
serial number is located on the packing slip. If any letters appear in the
serial number, do not type them in. Type in only the numbers. If you
98 VAXstation 2000 Hardware Installation Guide