Digital Equipment VAXstation 2000 Hardware Installation Manual page 100

After you press the halt button, you will see a display similar to the
following:
?02 EXT HLT
PC = 00001B46
» >
The system was trying to search the network for the operating system
software and did not find it. However, the networking hardware
and operating system software have not been installed yet. You will
be instructed later in this guide in Connect ThinWire Ethernet about
where to refer for installing networking hardware. You will install
the operating system software after completing the steps in this guide.
Proceed to Enter the Test Commands.
c. Or, you may see a display similar to the following:
KA410-A V2.1
F...E...D...C...B...A...9...8...7...6...5...4...3_..2_..1?,
83 BOOT SYS
- DUAO
%VMB-F-ERR, PC = nnnnnnnn
%VMB-I-STS, RO = nnnnnnnn
84 FAIL
» >
This example may also display one of the following devices: DUAl,
DUA2, MUAO, or ESAO. Ignore this message. This message indicates
that the system did not find the operating system on the device
mentioned (DUAO in this example). However, the operating system
software has not been installed yet. You will be instructed to install
the operating system software after completing the steps in this guide.
Proceed to Enter the Test Commands.
VAXstation 2000 Hardware Installation Guide 91