Drive; Wet Level; Dry/Wet; Settings Menu - Elektron Analog Heat MKII User Manual

5. THE USER INTERFACE

5.6 DRIVE

Sets the gain level in the effect circuit. A higher setting increases the effect of the selected circuit type,
typically resulting in more distortion. For more information, please see "4. SIGNAL FLOW" on page 12.

5.7 WET LEVEL

Sets the level of the signal coming from the effect. It is applied before the DRY/WET mix. It is used to match
the level of the dry signal for easy mixing of the two. For more information, please see "4. SIGNAL FLOW"
on page 12.

5.8 DRY/WET

Sets the mix between the clean signal and the signal that is affected by the effect. For more information,
please see "4. SIGNAL FLOW" on page 12.

5.9 SETTINGS MENU

Press [SETTINGS] to access the SETTINGS menu.
Scroll through the list of settings by using the PRESET/DATA knob. Open a highlighted menu by pressing
the PRESET/DATA knob or [YES]. To change the settings in the menus, first press and then turn the PRE-
SET/DATA knob. For more information, please see "6. THE SETTINGS MENU" on page 15.
5.10 PARAMETER PAGES
Access the parameter pages by pressing the corresponding key [AMP], [FILTER/EQ], [ENV], and [LFO].
There are two pages associated with each key (AMP has only one page). You can access the secondary
pages by pressing the [PARAMETER] key a second time. For more information, please see "7. PARAMETER
PAGES" on page 20.

5.11 PARAMETER EDITING

The four DATA ENTRY knobs are used to change the parameter values that are shown on the LCD screen.
(Some parameters also have dedicated knobs on the panel.) The physical location of the knobs on the front
panel correspond to the layout of the parameters on the screen.
• Press down and turn the DATA ENTRY to adjust the parameters in larger increments.
• Press [SETTINGS] + turn DATA ENTRY knob to quantize the parameter value to integers.
• Press [NO] + DATA ENTRY knob to reset the parameter to the default value.
• Press [NO] + [PARAMETER] key to reset the selected parameter group to default values.
• Use the [NO] key to exit an active menu, back to a higher level menu and to negate.

5.12 LCD SCREEN TITLE BAR

Preset number
• The Preset number and Preset name displays the currently selected preset. If you push one of the pa-
rameter keys, the title bar briefly shows the name of the active parameter page. This text is replaced by
parameter names when turning the DATA ENTRY knobs or the dedicated controllers.
• Between the preset number and the preset name, there is an indicator showing if the preset has been
altered. (i.e. changes that may be lost unless you save the preset.)
• The Audio input meter displays the level of the incoming audio.
• The Trigger icon signals that a trigger event has been generated by the Envelope Follower.
14
Change indicator Preset name Audio input meter Trigger icon