Table of Contents
Advertisement
• AUTO In Auto mode, Analog Heat automatically detects if the Overbridge plugin is running or not. With
Overbridge running, the Analog In is not routed through the effect to the Analog Out. (Same as OFF
setting.) If Overbridge is not running, the signal from analog is routed through the effect to the Analog
Out. (Same as IN+OUT setting.)
• IN+OUT Both Analog In and Analog Out are routed to the effect.
• IN Routs the signal from Analog In to the effect.
• OUT Routs the signal from the effect to Analog Out.
• OFF Neither Analog In nor Analog Out are routed to the effect.
You can use the Analog Heat as a regular audio interface and let signals pass in and out
unaffected by the effect. At the same time you can, via Overbridge, also use the effect to
process another set of audio signals.
AUTO mode is suitable for most use-cases. It lets the Analog Heat function both as a
standalone effect and together with Overbridge as a plugin, while still retaining its func-
tionality as a sound card.
6.3.4 KNOB MODE
Sets how the knobs on the panel affect the parameters. When you load a preset, the knobs positions
typically don't match their parameter values.
• JUMP immediately sets the value to the current knob position.
• In CATCH mode, turning the knob do not change the parameter value until the knob position matches
the presets stored value.
You can see the current value of the parameter in the LCD screens title bar while you turn the knob.
6.4 CONTROL IN
6.4.1 CONTROL IN A
• CONTROL MODE
Sets the port mode to adjust to different kinds of input signals. There are four modes: CV (Control
Voltage), EXPR (Expression Pedal), FOOTSW (Footswitch) and OFF.
• CV ZERO LEVEL (Available when mode is set to CV.)
Sets the Volt level at which CV modulation amount is zero. A control input level equal to this setting
corresponds to zero modulation. (-5.50 V–+5.50 V).
• CV MAX LEVEL (Available when mode is set to CV.)
Sets the Volt level at which CV modulation amount is max. A control input level equal to this setting
corresponds to full modulation. (-5.50 V–+5.50 V).
• EXPRESSION LEARN (Available when mode is set to EXPR.)
Sets the highest and lowest limit of the control input level.
CONTROL IN A/B
pedal to
position. Press YES to save settings.
• REVERSE DIRECTION (Available when mode is set to EXPR.)
Reverses the direction of how the Expression pedal sends control input signals.
• FOOTSW DEST (Available when mode is set to FOOTSW.)
Sets the destination of the control input from the Footswitch. The options are: TEMPO, ACTIVE PRE-
SET +, PRESET -, ENV TRIG
• FOOTSWITCH LEARN (Available when mode is set to FOOTSW.)
Sets the high and low limit of the control input level.
CONTROL IN A/B
. Press
save settings.
• REVERSE DIRECTION (Available when mode is set to FOOTSW.)
Reverses the direction of how the Footswitch pedal sends control input signals.
6.4.2 CONTROL IN B
The available settings are the same as for CONTROL IN A mentioned above.
YES and then move the expression pedal first to max and then to min
. Press
YES and then press the Footswitch pedal a couple of times. Press YES to
When in this setting, connect the Expression
When in this setting, connect the Footswitch pedal to
6. THE SETTINGS MENU
17
Hide quick links:
Advertisement
Table of Contents
