Channels - Elektron Analog Heat MKII User Manual

• PARAM INPUT
Makes it possible to control Analog Heat parameters from an external MIDI device sending CC/NRPN
data. (ON, OFF)

6.5.3 CHANNELS

• MIDI CHANNEL
Sets the MIDI channel that Analog Heat uses to send and receive MIDI data. When set to OFF, all MIDI
functionality is disabled. (1–16)
6.6 SYSTEM
6.6.1 USB CONFIG
• USB-MIDI ONLY
If you wish to disable the Overbridge integration functionality, then select this option. (ON, OFF)
• OVERBRIDGE
To use the Analog Heat as an Overbridge device, select Overbridge mode. (ON, OFF)
6.6.2 USB AUDIO CONFIG
Here you can set the output level of the audio over USB when you use the Analog Heat as a sound card.
Select USB OUTPUT LEV and set the desired output level. This setting only affects Analog Out L/R
(OUTPUT L/R). (0 dB–+18 dB)
6.6.3 OS UPGRADE
This menu option is used to upgrade the Analog Heat OS. To send the OS syx file, use our free SysEx
utility software C6 (or other compatible SysEx software). You can download the OS syx file and the C6
software from the Elektron website.
For the transfer to be possible, the device sending the OS syx-file must be connected to either the MIDI
IN or USB port of the Analog Heat. Also, input from MIDI or USB must be enabled on the Analog Heat.
For more information, please see "6.5.2 PORT CONFIG" on page 18.
Please note that the Analog Heat do not appear as an icon on your computer desktop.
1. Download the OS syx file and the C6 software to your computer.
2. Select OS UPGRADE on the Analog Heat (If you wish to cancel the waiting state, press [NO].)
3. Open the C6 software. Click "Configure" and select Elektron Analog Heat for MIDI In as well as
MIDI Out.
4. Drag the OS syx file to the C6 main window, then highlight it by single-clicking it.
5. Click the "send" button in the top left corner of the C6 window.
When receiving the OS, a progress bar and the message "RECEIVING" is visible on the Analog Heat LCD
screen. When the bar is full, the message "ERASING FLASH" is shown on the screen. This takes a short
while. When this process is complete, the OS is updated, and the unit reboots.
If the Analog Heat is receiving the OS upgrade through the MIDI ports, use the Elektron
TM-1 USB MIDI interface for up to 10x higher transfer speeds.
6.6.4 CALIBRATION
CALIBRATION starts the calibration routine for the drive circuits and filters. After selecting this option,
a popup window appears asking to confirm the calibration. Press [YES] to proceed with the calibration.
Please note that the calibration routine takes quite a while to complete.
6. THE SETTINGS MENU
19