Modulation; Options; Internal Tempo; Active At Start - Elektron Analog Heat MKII User Manual

6. THE SETTINGS MENU
• HIGH (Maximum input level 2,5 V, peak to peak)
• MAX (Maximum input level 1,2 V, peak to peak)

6.2 MODULATION

Here you can connect a number of modulation sources with their destinations and set the modulation
depth. For more information, please see "APPENDIX B: MODULATION SOURCES AND DESTINATIONS" on
page 30.
1. Turn the PRESET/DATA knob to scroll through the source list, and then select it by pressing PRESET/
DATA or [YES].
2. Turn the PRESET/DATA knob to scroll through the available destinations, and then select it by pressing
PRESET/DATA or [YES].
3. Lastly, set the modulation depth amount by turning the PRESET/DATA knob. A negative value gives an
inverted modulation. You can also use the rightmost DATA ENTRY knob to set the modulation depth. To
reset the modulation amount to 0, press and hold [NO].

6.3 OPTIONS

6.3.1 INTERNAL TEMPO

Sets the internal tempo. The tempo range is 30 – 300 BPM. This tempo controls the speed of the LFO.
The Analog Heat can also be set to respond to MIDI clock sent from external devices. If the device is
synced from either MIDI Clock or Overbridge, the Internal Tempo setting is locked from editing, and this
parameter instead shows the sync source together with the currently active (external) tempo. For more
information, please see "6.5.1 SYNC" on page 18.

6.3.2 ACTIVE AT START

Sets if Analog Heat is in Active or bypass mode when it is turned on.

6.3.3 ANALOG IN/OUT

Sets if the signal from the analog inputs is routed to the effect or not. It also sets if the signal from the
effect is routed analog outputs or not.
Analog Heat supports 4 channels of audio. Analog Input L/R are routed to the analog in-, and outputs,
and can optionally also be routed through the effect. FX Send L/R are always routed to the effect.
16
FX Send L/R
ANALOG IN
IN
Analog Input L/R
OVERBRIDGE
PLUGIN
FX Return L/R
EFFECT
OUT
OVERBRIDGE
AUDIO INTERFACE
ANALOG OUT
Analog Output L/R