Table of Contents
Advertisement
5. THE USER INTERFACE
5.6 DRIVE
DRIVE sets the gain level in the effect circuit. A higher setting increases the effect of the selected circuit type,
typically resulting in more distortion. For more information, please see "4. SIGNAL FLOW" on page 12.
5.7 WET LEVEL
WET LEVEL sets the level of the signal coming from the effect. It is applied before the DRY/WET mix. It is
used to match the level of the dry signal for easy mixing of the two. For more information, please see "4.
SIGNAL FLOW" on page 12.
5.8 DRY/WET
DRY/WET sets the mix between the clean signal and the signal that is affected by the effect. For more infor-
mation, please see "4. SIGNAL FLOW" on page 12.
5.9 SETTINGS MENU
Press [SETTINGS] to access the SETTINGS menu.
Scroll through the list of settings by using the PRESET/DATA knob. Open a highlighted menu by pressing
the PRESET/DATA knob or [YES]. To change the settings in the menus, first press, and then turn the PRE-
SET/DATA knob. For more information, please see "6. THE SETTINGS MENU" on page 16.
5.10 PARAMETER PAGES
Access the parameter pages by pressing the corresponding key [AMP], [FLTR & EQ], [ENV], and [LFO].
There are two pages associated with each key (AMP has only one page). You can access the secondary
pages by pressing the [PARAMETER] key a second time. For more information, please see "7. PARAMETER
PAGES" on page 24.
5.11 PARAMETER EDITING
The four DATA ENTRY knobs are used to change the parameter values that you see on the screen. (Some
parameters also have dedicated knobs on the panel.) The physical location of the knobs on the front panel
corresponds to the layout of the parameters on the screen.
• Press down and turn the DATA ENTRY to adjust the parameters in larger increments.
• Press [SETTINGS] + turn DATA ENTRY knob to quantize the parameter value to integers.
• Press [NO] + DATA ENTRY knob to reset the parameter to the default value.
• Press [NO] + [PARAMETER] key to reset the selected parameter group to default values.
• Use the [NO] key to exit an active menu, back to a higher level menu and to negate.
5.12 SCREEN INFORMATION
Preset number
14
Change indicator
Preset name
Audio input meter
Trigger icon
Current PARAMETER
page parameters
Current PARAMETER
page graphical info
Advertisement
Table of Contents
