Drive - Elektron Analog Heat MKII User Manual

7. PARAMETER PAGES
The device should be turned on at least 2 hours before you perform a calibration for its
circuits to warm up properly. If the unit has not yet warmed up for 2 hours, there is a cal-
ibration countdown counter which automatically initiates the calibration once it reaches
the timeout.
Also, please note that nothing should be connected to the device during the calibration.
Remember to turn down the volume on all speakers and headphones before activating
Test mode.
Analog Heat is factory calibrated. It should not be re-calibrated unless specifically stated
by Elektron Support or if prompted by the machine.
7. PARAMETER PAGES
Here follows a description of all the parameters that are on the PARAMETER pages. You access the param-
eter pages by pressing the [PARAMETER] keys. AMP has one page. FILTER/EQ, ENV, and LFO has two
pages. To access page one, press the [PARAMETER] key once. To access page two, press the [PARAME-
TER] key twice.
7.1 AMP PAGE
Press [AMP] once to access this parameter page.

7.1.1 DRIVE

Sets the gain level of the audio into the distortion circuit. A higher setting results in more distortion. Even
at zero level some of the circuits have a clear effect on the sound. (0.00–127.00)
7.1.2 WET
Sets the level of the signal that is affected by the effect. Use WET LEVEL to balance the Wet part so
that it has a similar level to the Dry part. This makes it easier to use the (Dry/Wet) MIX parameter to do
parallel distortion. For more information, please see "4. SIGNAL FLOW" on page 12. (This parameter
is written as WET LEVEL on the device panel.) (0.00–127.00)
7.1.3 DRY/WET
Sets the mix between the clean signal and the signal that is affected by the effect. (-64.00–63.00)
7.1.4 VOL
Sets the overall level of the sound and is saved as part of the preset. Use this to pick a good output gain
for the complete preset (i.e. from the output of the Dry/Wet mix). (0–127)
7.2 FILTER/EQ PAGE 1
Press [FILTER/EQ] once to access this parameter page.
7.2.1 FREQ
Sets the cutoff frequency of the filter. (0.00–127.00)
20