Setup Of Ip-200; Connecting Procedure Of Operation Panel With External Vehicle - JUKI AMB-289 Engineer's Manual

6. SETUP OF IP-200

(1) Connecting procedure of operation panel with external vehicle

It is possible for this operation panel to perform communication with the external vehicle other than the
control box. Connecting procedure is given below.
1. Communication by means of smart media card (3.3V voltage type only)
2. Communication by means of RS-232C
3. Input of signal by means of the connector for external input
1. Smart media card
It is possible to give and take data by using the smart media card.
For the smart media card, it is recommended to use SmartMedia of 3.3V voltage type which is prescribed by
SSFDC forum. The card is different in the position of notch as shown in the figure below. Judge it by the
position of notch.
(Caution) When the contact part becomes dirty, contact failure will be caused. Control so that the
contact part is not touched by hand, or that dust, oil or other foreign material does not
adhere to the contact part. Besides, be very careful of handling the card since the internal
data is broken by the static electricity or the like.
(Setting procedure)
2 When continuing inserting the smart media card, the card stops once in the state that it protrudes by
approximately 10 mm. When some force is applied to it, it is further inserted and goes to the end. When
it goes no further, reduce the force and it returns by approximately 1 mm. This work completes the
setting of the card.
< 3.3V type >
Contact part
−
Notch
< 5V type >
1 When the upper side cover located on the side of
operation panel is opened, there is the inserting
opening of the smart media card. Insert the card
there while facing the contact part to the front.
79 −