JUKI AMB-289 Engineer's Manual page 107

No.
Number of stitches of thread air-blow
This item sets the number of stitches of thread
air-blow in the neck wrapping process.
Compensation of button height in the neck wrapping process
This item compensates the button holding height in the
neck wrapping process and adjusts the wrapped condition.
Button positioning motion With/without
: With
This item sets whether the compensation motion of button positioning is
performed at the time of operation by operator before driving the sewing machine.
It is convenient to use this item when sewing buttons which are uneven in shape.
* Compensation value which has been set here is applied to one button sewing
only and the compensation value returns to 0 after completion of sewing.
Needle height at the time of button positioning
This item sets the angle which automatically lowers
needle at the time of button positioning motion.
Set the angle which is easy to perform positioning
according to kinds of buttons, neck wrapping height, etc.
Thread drawing motor start position in the
button sewing process
This item sets the thread slack amount at the
start of sewing to stabilize thread remaining
amount at the start of sewing.
Number of stitches to start thread drawing
motor operation in the button sewing process
This item sets number of stitches to hold the
thread slack amount set in No. S39.
Compensation of tension timing on cloth
side and rear side in the button sewing
process
This item changes the tension changeover
timing at the needle entry on cloth side and
rear side, and shifts the knotting position.
Item
: Without
− 103
Setting range Edit unit
0 to 20 1 stitch
–5.0 to 5.0 0.1mm
– – – – – –
0 to 130 1˚
0 to 100 1 pulse
1 to 2 1 stitch
–90 to 90 1˚
−
Initial display Remarks
6
0
Without
80
30
1
0