JUKI AMB-289 Engineer's Manual page 105

No.
Upper buttonhole interval (lateral)
This item sets the needle entry interval of top feed.
Needle entry interval of bottom feed (longitudinal)
This item sets the needle entry interval of bottom feed.
Needle entry interval of bottom feed (lateral)
This item sets the needle entry interval of bottom feed.
Number of stitches for button sewing
This item sets the number of stitches for button sewing.
Number of stitches at the start of button sewing (1 to 3 stitches)
This item sets the number of stitches at the start
of button sewing.
Compensation of lower left position of upper button
This item is set when cloth is pulled and the amount of blindstitch
on the left side is different from that on the right side.
Compensation of 3rd stitch at the start of sewing
This item compensates the position of 3rd stitch
at the start of sewing to prevent thread from
slipping off at the start of button sewing
Blindstitch width
This item has to be set within the range where needle
and tongue do not come in contact with each other.
Blindstitch amount
This item sets the blindstitch amount to cloth.
Buttonhole height of shank/marble button sewing
(Height from the feed plate)
This item is set to prevent the contact of needle
and buttonhole.
Thinning level of the stay button
This item decreases the number of cross-over stitches of
the lower side button at the time of stay button sewing.
: Without thinning
: Thinning level 2
Lateral compensation of needle entry of lower button at the
time of sewing counter button (front : 4 holes, rear : 2 holes)
Perform compensation to such an extent that needle does not come
in contact with buttonhole within the range of lower buttonhole.
* 1 The maximum value of the range of data editing depends on the setting of K05.
Item
: Thinning level 1
: Thinning level 3
− 101
Setting range Edit unit
0.10 to 0.05mm
6.00
0.10 to 0.05mm
6.00
0.10 to 0.05mm
6.00
2 to 32 2 stitchs
1 to 3 1 stitch
–1.00 to 0.05mm
1.00
0 to 0.5 0.05mm
0.0 to K05 0.2mm
–1.00 to 0.05mm
5.00
0.0 to 10.0 0.1mm
– – – – – –
0 to 0.30 0.05mm
−
Initial display Remarks
3.60
3.20
3.20
6
1
0
0
* 1
0.6
0.40
3.0
Without
thinning
0.30