Main Circuit Wiring - Panasonic VF0 Series Instruction Manual

Always confirm that the input power is OFF before starting wiring.
●
Failure to do so could lead to electric shock or fire.
Always connect the ground wire.
●
Failure to do so could lead to electric shock or fire.
Wiring work must be carried out by a qualified technician.
●
Failure to do so could lead to electric shock or fire.
Always install the unit before wiring.
●
Failure to do so could lead to electric shock or injury.
！
Do not connect an AC power supply to the output terminals (U, V, W).
●
Failure to do so could lead to injury or fire.
Confirm that the product's rated voltage and the AC power supply voltage
●
match.
Failure to do so could lead to injury or fire.
Tighten the terminal screws to the designated tightening torque.
●
Failure to do so could lead to fire.
■ Precautions
Note the following points carefully to prevent miswiring and misuse of the
inverter. (Devices may be broken.)
1) Connect the power supply to input terminals (R/L1, S/L2, T/L3) and the
2) Make sure to ground the supply neutral.
3) Do not connect anything other than the optional brake resister across
4) Use sleeved round crimp terminals for power supply and motor connections.
5) After wiring the main circuit, double check for tightness as access will be
6) When connecting directly to a large capacity power transformer (500kVA
7) Select connected devices and wire size according to the table on page 19.
17
Downloaded from www.Manualslib.com

Main Circuit Wiring

CAUTION
ATTENTION
motor to output terminals (U, V, W).
terminals DB+ and DB-. Never short these terminals to each other as this
will damage the internal electronics of the inverter.
limited once control circuit wiring is in place.
or more), always install a power factor improvement reactor (option) on the
inverter's input side.
manuals search engine