Panasonic VF0 Series Instruction Manual page 34

[Setting example: To change torque boost level from 5 (%) to 15 (%)]
[Setting precautions]
1. During operation, the parameters other than those that can be changed
2. If a stop signal is input while changing the data and the inverter stops, the
3. If the inverter stops at 0V while the data is being changed, the function
4. If the inverter starts operation while the data is being changed in the "0V
33
Downloaded from www.Manualslib.com
Operation state (for 50Hz operation)
Press the MODE button three times, and enter the "function
MODE
setting mode".
Press the
No. to P05.
Press the SET button to display the parameter P05 data.
SET
(The main display will flicker)
Press the
to "15". (The main display will flicker)
Press the SET button to set the data.
SET
Press the MODE button to enter the "output frequency, current
MODE
display mode". (The display will not change unless the MODE
button is pressed.)
will show data, but the data cannot be changed.
"operation preparation completed" state will be returned to.
setting will be returned to the "0V stop state".
stop state", the "output frequency, current display mode" will be returned to.
manuals search engine
(up) button four times, and change the parameter
(up) or (down) button to set the data display value
5 0. 0
P 0 1
P 0 5
0 5
1 5
P 0 6
5 0. 0