Snmp Configuration; Ro Community Setup - Cisco D9887B Installation And Configuration Manual

SNMP Configuration

The trap reporting to SNMP allows the user to set which traps will be sent. SNMP
control of the D9887B receiver requires the unit to identify the "Community" for read
only and read/write access. These are configured using the steps below.
To access the SNMP configuration, use the following steps:
1 Press the Menu button.
2 Use the Up and Down buttons to move the cursor to "SNMP," then press the
Enter button.

RO Community Setup

To change the RO Community, follow the steps below:
Use the Up and Down buttons to move the cursor to "RO Community," then press
the Enter button.
Name
1 Use the Up and Down buttons to select "Name," then press the Enter button.
2 Use the Up and Down buttons to change the character and then the Left and
Right buttons to change the Name, then press the Enter button to save the
selection.
78-4043743-01 Rev A

SNMP Configuration

157