Receive 1 - Cisco D9887B Installation And Configuration Manual

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
Setting when to Restore to the Primary
Note: This is not changeable when using "TrigDecErr" ("Pri Rest" is set to "Never" in
this case).
1 Use the Up and Down buttons to move the cursor to "Pri Rest," then press the
Enter button.
2 Use the Up and Down buttons to select "Never", "WhnPriRet" (When the
Primary Returns), or "OnBkpFail" (On Backup Failure), then press the Enter
button to save the selection.
Setting the Switchover Timeout
The Switchover Timeout is the delay between the detection of the failure and the
switch to either the backup or back to the primary (controlled by the Restore to
Primary setting) receive group.
1 Use the Up and Down buttons to move the cursor to "Timeout," then press the
Enter button.
2 Use the Up and Down buttons to select the time in seconds (from 0 to 10 seconds
in 0.5 second intervals), then press the Enter button to save the selection.

Receive 1

This section allows the user to setup the receive function of the first receive group.
1 Use the Up and Down buttons to move the cursor to "Receive 1," then press the
Enter button.
102 78-4043743-01 Rev A