No Psi Mode - Cisco D9887B Installation And Configuration Manual

2 Use the Up and Down buttons to set the desired audio index (0 – 65535), then
press the Enter button to save the selection.
Audio 4 Index
Note: This menu is only available if the unit is equipped with a second decoder in
Configuration 1.
1 Use the Up and Down buttons to move the cursor to "Aud4 Index," then press
the Enter button.
2 Use the Up and Down buttons to set the desired audio index (0 – 65535), then
press the Enter button to save the selection.
Note: Use the previous steps to setup the Priority 2 as well.

No PSI Mode

This mode should only be used if both the PID information and audio/video
formats are known about the stream.
Note: This menu is only available if the "Tune Mode" is set to "No PSI."
PCR PID
1 Use the Up and Down buttons to move the cursor to "PCR PID," then press the
Enter button.
2 Use the Left and Right buttons to select the column to edit, then use the Up and
Down buttons to set the desired PCR PID in the stream, then press the Enter
button to save the PID.
Video PID
1 Use the Up and Down buttons to move the cursor to "Video PID," then press the
Enter button.
78-4043743-01 Rev A
MPEG-2/MPEG-4 4:2:0 Decoder (1 Video, 2 Audio) Option
121