Services Setup - Cisco D9887B Installation And Configuration Manual

4 Once the desired input has been set to active, the specific options of that input
card can be set by clicking on the Window (
When the Window icon is clicked, an edit window will appear with the specific
options for that card. Use the drop down menus and input boxes to complete the
edit form. Click the Apply button at the bottom of the form to save the settings.
The current settings for any of the input cards can be verified by clicking on the
Down button next to the desired input.

Services Setup

After the desired input has been selected and configured, the session needs to be
setup.
All of the following options can be found under the "Services" menu.
Services
The "Services" edit menu defines which program is going to be decoded. These can
be setup in four different ways depending upon the application. The four different
setup options are: "Auto", "PID-Locked", "Priority", and "No PSI." Auto mode should
only be used if nothing is known about the PIDs in the TS. Priority mode is primarily
used for redundancy. PID-Locked mode should always be used unless one of the
above conditions is true. No PSI mode should only be used for streams that do not
contain any PSI information. To setup these decoder settings use the following steps:
1 Click on the RDS 1 or RDS 2 tab of the corresponding RDS that needs to be
configured.
Note: In a Configuration 1 D9887B receiver, there will only be a RDS 1 tab.
78-4043743-01 Rev A
) icon next to the active input.
Configuration
173