Cisco D9887B Installation And Configuration Manual page 78

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
Ancillary Data Packets
This controls the embedding of the Ancillary Data Packets (ADP) into the VANC of
the SDI output.
1 Use the Up and Down buttons to move the cursor to the desired type of
Ancillary Data Packet ("EIA-608CC", "EIA-708CC", "TTX S2031M", "Source ID",
or "SCTE 127", "AFD"), then press the Enter button.
2 Use the Up and Down buttons to choose "Enabled" or "Disabled," then press the
Enter button to save the selection.
3 Use the Up and Down buttons to select "Line" for the ADP and press the Enter
button.
4 Use the Up and Down buttons to change the line number (4 – 15) in which the
ancillary data will be located, then press the Enter button.
Note: Repeat steps 1-4 above to change EIA-708CC, TTX S2031M, Source ID,
SCTE-127 and AFD.
NTSC Waveforms
To enable NTSC items, use the following steps.
1 Use the Up and Down buttons to move the cursor to "Line 21CC," then press the
Enter button.
2 Use the Up and Down buttons to select "Enabled" or "Disabled," then press the
Enter button to save the selection.
Note: Repeat steps 1-2 above to change AMOL and TVG2x.
54 78-4043743-01 Rev A