Cisco D9887B Installation And Configuration Manual page 98

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
1 Use the Up and Down button to move the cursor to "Disp Mode," then press the
Enter button.
2 Use the Up and Down buttons to select either "Letterbox" or "Cropped," then
press the Enter button to save the selection.
SD Mode Setup
This sets the video frame conversion when the SD output video format has a
different aspect ratio form the input video. "Letterbox" provides bars to fill the
screen, either top and bottom (letterbox) or on each side (pillarbox). The "Cropped"
setting expands (without distortion) the video so that it fills the video frame and
deletes the parts that extend beyond the frame. The "Anamorph" setting stretches the
video to fit the full screen.
1 Use the Up and Down button to move the cursor to "SD Mode," then press the
Enter button.
2 Use the Up and Down buttons to select either "Letterbox", "Cropped", or
"Anamorph", then press the Enter button to save the selection.
SD Output Setup
Follow the steps in this section to set the outputs to SD-SDI and HD-SDI.
1 Use the Up and Down button to move the cursor to "Output 1," then press the
Enter button.
2 Use the Up and Down buttons to select the desired output format ("SD" or
"HD"), then press the Enter button to save the selection.
Note: Repeat the steps above to change to the desired output setting for "Output
2."
Note: The frame rate of the SD output follows the setting that is set for the
"Format:" entry in the "Video" settings.
74 78-4043743-01 Rev A