Making A Sample Settings - Roland MV-8800 Owner's Manual

Making a sample settings

1.
Access the PARTIAL EDIT screen as describe"Making a partial settings" (p. 102).
2.
Press [F1](Sample Edit).
The SAMPLE EDIT screen (Screen Guide; p. 128) will appear.
1
2
3
4
1 SMT number, sample name
Specifies the SMT number and sample name that you are actually editing.
2
2 Start Point
Adjusts the point at which the playback of the sample starts.
Loop Point
3
Adjusts the point at which repeated portion (the second and subsequent times) will begin playing.
Set this if you want to the sample to loop from a point other than the Start Point.
End Point
4
Adjusts the point at which the playback of the sample will end.
Loop Mode
5
Specifies how the sample will play.
6 Loop Tune
Adjust the playback pitch of the loop region in step of one cent.
●
You can use [SHIFT] + CURSOR [
●
When the cursor is located at Start Point, Loop Point, or End Point, you can use PREVIEW [TO (
[FROM (
●
For details on each parameters refer to "SAMPLE EDIT screen" (Screen Guide; p. 128).
5
6
] [ ] [
)] to audition the data before or after that point.
] [ ] to zoom-in or zoom-out the waveform display.
Making a partial settings
)] /
MV-8800 Owner's Manual
5
M-105