Installing The Cutting Units - Toro Reelmaster 5410-D Operator's Manual

4

Installing the Cutting Units

Parts needed for this procedure:
1 Front hose guide-R.H.
1 Front hose guide-L.H.
Procedure
1. Remove the reel motors from the shipping
brackets.
2. Remove the shipping brackets and discard.
3. Remove the cutting units from the cartons.
Assemble and adjust as described in the cutting
unit Operator's Manual.
4. Make sure the counter weight
installed to the proper end of the cutting unit as
described in the cutting unit Operator's Manual.
1. Counter weight
5. All the cutting units are shipped with the turf
compensation spring mounted to the right side
of the cutting unit. The turf compensation spring
must be mounted to the same side of the cutting
unit as the reel drive motor. Reposition the turf
compensation as follows:
A. Remove the 2 carriage bolts and nuts
securing the rod bracket to the cutting unit
tabs (Figure
(Figure 4) is
Figure 4
5).
1. Turf compensation spring
2. Rod bracket
B. Remove the flange nut securing the spring
tube bolt to the carrier frame tab
Remove the assembly.
C. Mount the spring tube bolt to the opposite
tab on the carrier frame and secure with the
flange nut. The bolt head is to be positioned
to the outer side of the tab as shown in
Figure
1. Opposite carrier frame tab
D. Mount the rod bracket to the cutting unit
tabs with the carriage bolts and nuts
6).
Important:
#5 (right front) cutting units
use the rod bracket mounting nuts to
install the hose guides to the front of the
cutting unit tabs
guides should lean toward the center
cutting unit
g003320
14
Figure 5
3. Spring tube
6.
Figure 6
2. Rod bracket
On the #4 (left front) and
(Figure 8). The hose
(Figure 8 and Figure
Figure 7
g003949
(Figure 5)
g003967
(Figure
(Figure 7),
9).
g014684