Replacing The Hydraulic Filters; Checking The Hydraulic Lines And Hoses - Toro Reelmaster 5410-D Operator's Manual

9. Check the level of the hydraulic fluid and add
enough to raise level to the Full mark on the
dipstick.
Important:
Do not over-fill.
Replacing the Hydraulic
Filters
The hydraulic system is equipped with a service
interval indicator (Figure
at operating temperature, view the indicator, it should
be in the Green zone. When the indicator is in the
Red zone, change the hydraulic filters.
1. Hydraulic filter restriction indicator
Important:
Use of any other filters may void the
warranty on some components.
1. Position the machine on a level surface, lower
the cutting units, stop the engine, engage the
parking brake, and remove the key from the
ignition switch.
2. Clean the area around the filter mounting area
and place a drain pan under filter
and (Figure 89).
1. Hydraulic filter
87). With the engine running
Figure 87
(Figure
Figure 88
1. Hydraulic filter
3. Remove the filter.
4. Lubricate the gasket on the new filter with
hydraulic oil.
5. Ensure that the filter mounting area is clean.
6. Install the filter by hand until the gasket contacts
the mounting surface, then rotate it an additional
g004132
1/2 turn.
7. Repeat the procedure on the other filter.
8. Start the engine and let it run for about two
minutes to purge air from the system.
9. Stop the engine and check for leaks.
Checking the Hydraulic
Lines and Hoses
Daily, check hydraulic lines and hoses for leaks, kinked
88)
lines, loose mounting supports, wear, loose fittings,
weather deterioration, and chemical deterioration.
Make all necessary repairs before operating.
g021271
55
Figure 89
g004150