Toro Reelmaster 5410-D Operator's Manual page 16

Figure 10
1. Snapper pin
8. For the front cutting units, slide a cutting unit
under the lift arm while inserting the carrier frame
shaft up into the lift arm pivot yoke
Figure 11
1. Lift arm
2. Carrier frame shaft
9. Use the following procedure on the rear cutting
units when the height of cut is above 3/4 inch.
A. Remove the lynch pin and washer securing
the lift arm pivot shaft to the lift arm and
slide the lift arm pivot shaft out of the lift arm
(Figure 12).
g003975
2. Cap
(Figure 11).
g003977
3. Lift arm pivot yoke
1. Lift arm pivot shaft lynch pin and washer
B. Insert the lift arm yoke onto the carrier
frame shaft
C. Insert the lift arm shaft into the lift arm and
secure it with the washer and lynch pin
(Figure 12).
10. Insert the cap over the carrier frame shaft and
lift arm yoke.
11. Secure the cap and the carrier frame shaft to
the lift arm yoke with the snapper pin. Use the
slot if a steering cutting unit is desired or use the
hole if the cutting unit is to be locked in position
(Figure 10).
12. Secure the lift arm chain to the chain bracket
with the snapper pin
number of chain links described in the cutting
unit Operator's Manual.
1. Lift arm chain
13. On the #4 (left front) and #5 (right front) cutting
units, insert the reel motor hoses into the
respective hose guide.
14. Coat the spline shaft of the reel motor with clean
grease.
15. Oil the reel motor O-ring and install it onto the
motor flange.
16. Install the motor by rotating it clockwise so that
the motor flanges clear the bolts
Rotate the motor counterclockwise until the
flanges encircle the bolts then tighten the bolts.
16
Figure 12
(Figure 11).
(Figure 13). Use the
Figure 13
2. Chain bracket
(Figure
g003979
g003948
14).