Service Interval Chart
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Lubrication
Greasing the Bearings and
Bushings
If you operate the machine under normal conditions,
lubricate all grease fittings for the bearings and
bushings after every 50 hours of operation with No.
2 General Purpose Lithium Base Grease. Lubricate
bearings and bushings immediately after every
washing, regardless of the interval listed.
The grease fitting locations and quantities are as
follows:
•
Pump drive shaft (3)
(Figure
61)
Figure 60
•
Cutting unit lift arm cylinders (2 each)
44
Figure 61
(Figure
Figure 62
decal125-2927
g021216
62)
g012150