Figure 55
1. Bypass valve
2.
Close the bypass valve before starting the
engine. However, do not exceed 7-11 N-m. (5-8
ft.-lb) torque to close the valve.
Important:
Running the engine with
the bypass valve open will cause the
transmission to overheat.
Jacking Points
Note:
Use jack stands to support the machine when
required.
•
Front—rectangular pad, under the axle tube,
inside each front tire
Figure 56
1. Front jacking point
•
Rear—rectangular axle tube on the rear axle.
(Figure
56).
Tie Downs
•
Front—the hole in the rectangular pad, under the
axle tube, inside each front tire
g003995
1. Front tie down
•
Rear—each side of the machine on the rear frame
(Figure
58).
1. Rear tie down
g004554
39
(Figure
57).
Figure 57
Figure 58
g004558
g004555