Toro Reelmaster 5410-D Operator's Manual page 22

InfoCenter Icon Description (cont'd.)
Engine
Key switch
Indicates when the cutting units are
being lowered
Indicates when the cutting units are
being raised
PIN code
CAN bus
InfoCenter
Bad or failed
Bulb
Output of TEC controller or control
wire in harness
Switch
Operator must release switch
Operator should change to indicated
state
Symbols are often
combined to form
sentences. Some
examples are shown
below
Operator should put machine in
neutral
Engine start denied
Engine shutdown
Engine coolant too hot
DPF ash-accumulation
notification—Refer to
the Diesel-Oxidation Catalyst (DOC)
and the Soot Filter (page 48)
details.
Sit down or set parking brake
Using the Menus
To access the InfoCenter menu system, press the
menu access button while at the main screen. This
will bring you to the main menu. Refer to the following
tables for a synopsis of the options available from
the menus:
Main Menu
Menu Item
Faults
Service
Diagnostics
Settings
About
Service
Menu Item
Hours
Counts
Diagnostics
Menu Item
Cutting Units
Servicing
Hi/Low Range
for
PTO
22
Description
Contains a list of the recent
machine faults. Refer to
the Service Manual or your
Authorized Toro Distributor for
more information on the Faults
menu and the information
contained there.
Contains information on the
machine such as hours of
use counters and other similar
numbers.
Displays the state of each
machine switch, sensor and
control output. You can use
this to troubleshoot certain
issues as it will quickly tell you
which machine controls are on
and which are off.
Allows you to customize and
modify configuration variables
on the InfoCenter display.
Lists the model number, serial
number, and software version
of your machine.
Description
Lists the total number of hours
that the machine, engine and
PTO have been on, as well
as the number of hours the
machine has been transported
and service due.
Lists numerous counts the
machine has experienced.
Description
Indicates the inputs, qualifiers
and outputs for raising and
lowering the cutting units.
Indicates the inputs, qualifiers
and outputs for driving in
transport mode.
Indicates the inputs, qualifiers
and outputs for enabling the
PTO circuit.