Cessna 172SPHUSR05 Pilot Operating Handbook page 480

S ECTION 9 S U P PLEM ENTS
-
S UPPLEM ENT 24
Press the S ET (RES ET) button and the left two digits will flash,
these are the hour digits. Press the ADV (ST/SP) button to change
to the current hour. Press the S ET (RESET) button and the right
two digits will flash ; these are the minute digits.
(ST ISP) button to change to the current minute.
S ET (RES ET) button and both the hour and minutes will be
displayed. If the minutes were changed, the clock is stopped and
holding. When the time reference being used to set the clock
reaches the exact minute shown on the display, press the ST/S P
button. The display will show the date and start the clock running.
If the minutes were not changed, the minutes will continue to run
and not need to be restarted .
When operating i n the Timer Mode the word "TI M E R" is shown
on the display directly below the digits and indicates that the
elapsed time is being displayed. The timer can be reset to 00:00,
started , stopped, or restarted . It counts in minutes and seconds for
the first hour and then counts in hours and minutes to 23 :59. The
timer continues to keep elapsed time when the display is in the
clock mode. Pushing the ST/SP (ADV) button alternately starts and
stops the elapsed counter with each push.
button when pushed resets the timer to 00:00.
There i s n o change to the airplane performance when this
equipment is i nstalled.
S24 6
-
FAA APPROVED
-
S ECTIO N 5
PE R FO RMANC E
C ESSNA
MODEL 1 72S
Press the ADV
Then press the
The R ES ET (SET)
Jan 3 1 /02