Roland CD-2e Owner's Manual page 53

When you make settings for automatic recording, the procedure for starting to record will be
as follows.
1
Press the [ (Record)] button.
fig.autorec01-e.eps
2
Press the [
The CD-2e will be in recording-standby mode.
fig.autorec02-e.eps
3
Start performing.
When the CD-2e detects audio, recording will begin automatically.
* In order to avoid losing any audio at the beginning of the performance, recording will actually
begin up to 0.5 seconds earlier than the point at which audio exceeding the specified level is
detected.
4
Press the [ (Stop)] button to stop recording.
The recorded song will be added to the SD memory card or to the end of the CD-R/RW
disc.
Important
● Recording will pause when you press the [
once again, recording will begin automatically. The point at which recording is resumed
will be the next song.
Automatic recording will not work if you've specified a count-in (Page 58).
●
Blinking
(Play)] button.
Blinking
Convenient Functions for Recording
(Play)] button. When audio is detected
(continued)
53