Service manual
Replacing the LED engine
1.
Follow the procedure in "Replacing the reflector"
on page 36.
2.
Gently remove the LED engine with your fingers.
3.
Follow the procedure in reverse order.
4.
Replace the LED engine.
NOTE! In the light engine and light engine
assembly, make sure that the position screws (1)
are turned in a way that they fit in the slot.
Before you fully tighten the screws make sure that
the LED engine is aligned according to the marks
you made in "Replacing the lens" on page 36.
5.
Follow the procedure in reverse order.
Replacing the driver board
1.
Follow step 1-8 in the procedure in "Replacing the
lens" on page 32.
2.
Disconnect the four connectors (1).
MAC Encore Performance - Revision A, 12-20-2017
Figure 89: Removing the LED engine
1
Figure 90: Replacing the LED engine
1
Figure 91: Removing four connectors
1
37 of 46