Rear End; Removing The Rear End Covers - Martin MAC Encore Performance Service Manual

Service manual
7. Replace the framing blade
NOTE! Make sure that the spring (5) stays in
place.
8. Follow the procedure in revese order.

Rear end

Removing the rear end covers

1. Remove the head covers. See "Removing the
head covers" on page 20.
2. Remove the front side covers. See "Removing the
front side covers" on page 20.
3. Remove the four Torx20 screws (1).
4. Remove the rear end plactic cover (2).
5. Remove the two Torx20 screws (3) on each side.
6. Remove the two rear end covers (4).
7. Follow the procedure in reverse order.
MAC Encore Performance - Revision A, 12-20-2017
Figure 71: Position of the spring
1
2
Figure 72: Removing rear end plastic cover
3
Figure 73: Removing rear end cover
5
1
4
31 of 46