Service manual
Replacing the animation wheel
1.
Remove the head covers. See "Removing the
head covers" on page 20.
2.
Remove the front side covers. See "Removing the
front side covers" on page 20.
3.
Remove the multimodule. See "Replacing the
multimodule" on page 26.
4.
Loosen the five Torx20 screws (1).
5.
Place the framing module (2) next to the gobo and
effect module (3).
6.
Gently loosen the magnetic holder (4) with a small
flatheaded screwdriver.
7.
Replace the animation wheel (5).
NOTE! Make sure that the indexing marks (6) are
aligned.
8.
Follow the procedure reverse order.
MAC Encore Performance - Revision A, 12-20-2017
Figure 65: Loosening five Torx20 screws
2
4
5
Figure 66: Placing the framing module
5
6
Figure 67: Aligning the indexing marks
1
3
6
29 of 46