Repair And Maintenance; Base; Removing The Base Covers - Martin MAC Encore Performance Service Manual

Service manual

Repair and maintenance

Base

Removing the base covers

1. Disconnect the fixture from power and let it
cool for 15 minutes until the PSU have been
discharged.
2. Remove the two screws (1) on the front and back
cover.
3. Pull off the base covers (2) sideways.
4. To remove the voltage insulation covers (3),
loosen the four Torx10 screws (4) on each side of
the base and pull up the cover.
5. Follow the procedure in reverse order.
MAC Encore Performance - Revision A, 12-20-2017
Figure 8: Removing the screws
Figure 9: Pulling of the base covers
3
4
Figure 10: Removing the voltage insulation cover
1
2
4
10 of 46