Replacing The Lamp - Martin MAC 2000 Wash User Manual

Replacing the lamp

Important! Do not touch the quartz bulb with bare fingers.
Avoid placing stress on the lamp, as this may
weaken the bulb and cause premature failure.
The lamp can be replaced with either a:
• Philips MSR 1200 SA/DE GOLD (Martin P/N 97010310), or
an
• Osram HTI 1200 SharXS (Martin P/N 97010304).
Both lamps are available from your Martin dealer.
The clear quartz bulb must be clean and free of any oils
from your fingers. Clean the lamp with an alcohol wipe and
polish it with a dry cloth, particularly if you accidentally
touch the bulb.
To replace the lamp:
1 Disconnect the fixture from power and allow it to cool. Lock
the head horizontally with the top up.
2 See Figure 6. Release the 4 quarter-turn fasteners marked
with arrows on the rear plate. Pull the lamp assembly
straight back as far as it goes and let it rest on its retaining pins.
3 See Figure 7. Pull the retention spring on the left-hand end of the lamp socket up and then swing the end of
the lamp out. Pull the other end out of the socket.
4 Inspect the socket for corrosion (see "Replacing the lamp socket" on page 28) and replace if necessary.
5 See Figure 8. With the nipple on the bulb facing the back,
insert the right end of the new lamp in the socket. Pull up
on the left spring and snap the other end into place.
6 Lift the lamp assembly so that the lamp is level with the
center of the reflector. Push the assembly straight in until it
seats, making sure the lamp passes through the reflector
opening. Lock the 4 quarter-turn fasteners.
7 When installing a new lamp, reset the lamp hour and lamp
strike counters as described in "Time" on page 15.
Routine maintenance
Figure 7: Lamp removal
Figure 8: Lamp insertion
27