Replacing The Tilt Sensor Pcba; Replacing The Tilt Belt - Martin MAC Encore Performance Service Manual

Service manual
13. Make an "eye" of the pan belt (7).
14. Gently tighten the belt over the motor pulley
NOTE! Before you install the pan bracket, place
the cable ties as it will be difficult to place them
after the pan bracket has been installed.
15. To make sure that the pan belt moves freely
before you tigthen the pan belt tensioner, release
the nut on the pan belt tensioner and turn the
head several times.
16. Tighten the pan belt tensioner.
17. Follow step 1 to 6 in reverse order.
18. Follow the procedure in "Removing the yoke
covers" on page 15 in reverse order.
NOTE! Make sure that the wires in the center of
the yoke run freely.

Replacing the tilt sensor PCBA

1. Remove the yoke covers. See "Removing the
yoke covers" on page 15.
2. Remove the two Torx10 screws (1).
3. Remove the connector.
4. Replace the tilt sensor PCBA.
5. Follow the procedure in reverse order.

Replacing the tilt belt

1. Remove the yoke covers. See "Removing the
yoke covers" on page 15.
2. Remove the tilt sensor PCBA. See "Replacing the
tilt sensor PCBA" on page 18.
3. Loosen the locknut (1).
4. Push the belt tensioner to the left (2).
MAC Encore Performance - Revision A, 12-20-2017
7
Figure 32: Making an "eye" of the pan belt
1
Figure 33: Replacing the tilt sensor PCBA
1
2
Figure 34: Loosening the locknut
18 of 46