Replacing The Framing Blade - Martin MAC Encore Performance Service Manual

Service manual

Replacing the framing blade

1. Remove the head covers. See "Removing the
head covers" on page 20.
2. Remove the front side covers. See "Removing the
front side covers" on page 20.
3. Remove the multimodule. See "Replacing the
multimodule" on page 26.
4. Loosen the five Torx20 screws (1).
5. Place the framing module (2) next to the gobo and
effect module (3).
6. Remove the two Torx10 screws (4).
MAC Encore Performance - Revision A, 12-20-2017
Figure 68: Loosening five Torx20 screws
2
Figure 69: Placing the framing module
Figure 70: Removing the Torx10 screws
1
3
4
30 of 46