Servo Introduction; Battery Installation - Freewing REBEL FJ20311 User Manual

Servo introduction

A servo or reversed servo is defined as follows:
When the servo input signal changes from
1000ųs to 2000ųs, if the servo arm rotates
clockwise, it's a positive servo. If it rotates
counter clockwise, it's a reversed servo.
Pos. / Rev. Cable length
Servo No.
200 mm
1 Positive
2 360 mm
Positive
360 mm
3
Positive
4 300 mm
Positive
300 mm
5
Reverse
6 100 mm
Positive
100 mm
7
Positive
Servo connection instruction
1.Use Y-harness to connect the No.1 and No. 7 the two servos.
2.Use Y-harness to connect the No.2 and No.3 the two servos.
3.Use Y-harness to connect the No.4 and No.5 the two servos.

Battery Installation

Battery Hatch
Battery
Remove Battery Hatch, place the battery on the deck
and secure it with the Velcro straps.
Before connecting the battery to the ESC, please switch
on the transmitter and ensure that the throttle is in the
low position. Engage the Kill switch is one is assigned.
Rebel 70 EDF Jet
No.: FJ20311
Item
Version No.: FJ20311-V01
__ . . /
.. ..--
-
iiii
-5-
11 -- -
...
- -- --- - · . ,
/'
El
The recommended battery is: 45 14.8V 2600mAh 35C
If you wish to use a different sized battery refer to
the battery cabin size to ensure it will fit:
L= 140mm; W= 50mm; H=55mm
4514.SV 2200mAh - 45 14.8V 3200mAh
Discharge rate of C > 35C
Ensure that the weight difference between different
sizes/types of batteries does not affect your CG
EN