Servo Introduction; Battery Installation - Freewing F-86 SABRE User Manual

Servo introduction

A servo or reversed servo is defined as follows:
When the servo input signal changes from 1000ųs to
2000ųs, if the servo arm rotates clockwise, it's a
positive servo. If it rotates counter clockwise, it's a
reversed servo.
If you decide to purchase another brand of servo,
refer to the following list to ensure that it is
correct type and size .
Sevo installing position Servo No.
Nose gear steeing sevo
Ail e ron sevo (Let)
2
Ail e ron sevo (Right)
3
Fl a p sevo (Let) 4
Fl a p sevo (Right) 5
6
Elevator sevo (Let)
7
Elevator sevo (Right)
8
Rudder sevo

Battery Installation

-
lift tape to
'
�
remove the
battery hatch
Lift tape to remove the battery hatch.
Use the Velcro strap to secure the battery.
Before connecting the battery to the ESC, switch
on the transmitter and ensure that the throttle is
in the low position. Engage the kill switch if you
have one assigned.
F-86 Sabre
Item No.: FJ2031
Version No.: FJ2031-V01
www.modellmarkt24.ch; www.modellmarkt24.ch;
Sevo
Pos./Rev.
Cabl e Length
Positive
200mm
Positive
500mm
Positive
500mm
Positive
300mm
Reverse
300mm
Reverse
150mm Servo connection instructions
1.Use a Y-cabl e to join the No.1 and No.8 servos.
Positive
150mm
2.Use a Y-cabl e to join the No.2 and No.3 servos.
3.Use a Y-wire to join the No.4 and No.5 servos.
Reverse
150mm
4.Use a Y-wire to join the No.6 and No.7 servos.
Battery
hatch
-Battery
The standard battery is:
4S 14.SV 4000mAh 35C
or
6S 22.2V 3700mAh 35C
The advised battery capacity and discharge rate is the
following:
4S 14.SV 3200mAh - 4S 14.SV 4500mAh
6S 22.2V 3200mAh - 6S 22.2V 4500mAh
Discharge rate of C ;, 25C
Different battery weights may affect the CG, check the CG if you
use a different size battery.
-9-
www.modellmarkt24.de www.modellmarkt24.de
EN
I
I