2.9.1.2.
INITIAL SENSOR CHECKS AND ADJUSTMENTS
3.
SOFTWARE SETUP AND OPERATION
3.1.
CONFIGURATION AND SETUP
3.1.1.
HOMESCREEN
08354A DCN7303
Instructions for checking and calibrating pressure and flow using customer-
owned flow and pressure standards can be found in Sections 4.1.1, 4.1.2, and
4.1.3
Instructions for performing an optical sensor check and PMT adjustment are
provided in Section 4.1.4.
Configuration and setup instructions are provided in Section 3.1, instructions for
updating firmware in Section 3.2, and operation instructions in Section 3.3.
Configure pages, set up reporting parameters, and customize any of several
features to suit user needs.
Three meters at the bottom of Home page display user-selectable parameters and
their values. To select, go to the Home Configuration page by touching the
configuration button
Figure 3-1). The Home page can also be configured through the Setup menu
(Section 3.1.11).
Teledyne API Model T640 PM Mass Monitor
(shortcut) and following the onscreen instructions (see
29