Safety; Emc; Installation And Hardware Setup; Unpacking - Teledyne T640 User Manual

1.3.

SAFETY

1.4.

EMC

2.

INSTALLATION AND HARDWARE SETUP

2.1.

UNPACKING

08354A DCN7303
IEC/EN 61010-1:2010 (3
for measurement, control, and laboratory use.
CE: 2006/95/EC, Low-Voltage Directive
IEC/EN 61326-1, Class A Emissions/Industrial Immunity
EN55011 (CISPR 11), Group 1, Class A Emissions
FCC 47 CFR Part 15B, Class A Emissions
CE: 2004/108/EC, Electromagnetic Compatibility Directive
This section addresses the procedures for unpacking the instrument and
inspecting for damage, presents clearance specifications for proper ventilation,
and shows the instrument layout.
Verify that there is no apparent external shipping damage.
occurred, please advise the shipper first, then Teledyne API.
Included with your instrument is a printed record of the final performance
characterization performed on your instrument at the factory. This record, titled
Final Test and Validation Data Sheet, is an important quality assurance and
calibration record and should be placed in the quality records file for this
instrument.
WARNING – ELECTRICAL SHOCK HAZARD
Never disconnect PCAs, wiring harnesses or electronic subassemblies
while under power.
With no power to the unit, carefully remove the top cover of the instrument and
check for internal shipping damage by carrying out the following steps:
1. Carefully remove the top cover and check for internal shipping damage.
Teledyne API T640 PM Mass Monitor
rd
Edition), Safety requirements for electrical equipment
If damage has
12