Flx-Bi4 And Flx-Bo4A Wiring - Intelix FLX-3232 Installation And Operation Manual

3. Slide the I/O card between the guide rails until it is firmly seated.
4. Secure the I/O card by tightening the thumb screws.
5. Connect the appropriate cabling to the I/O card.
6. Power on the matrix.

FLX-BI4 and FLX-BO4A Wiring

A compatible HDBaseT with control transmitter or receiver is required to pass the control signals
to the source or display devices.
To connect the FLX-BI4 to a compatible transmitter or the FLX-BO4A to a compatible receiver, a
Cat 6 or greater cable with a TIA-568B crimp termination on the RJ45 connector must be used.
The Cat 6 cable must not exceed 40 meters for 3D content. The Cat 6 cable must not exceed 70
meters for 2D content.
To use the IR extension capabilities of the FLX-BI4, the DIGIB-EYE (wideband IR receiver) and
DIGIB-EMT (wideband IR emitter) will need to be connected to the appropriate IR ports. These
parts are not included with the HDBaseT I/O cards.
FLX-3232 Installation Guide
13