Table of Contents
Advertisement
Networking Page
Click the Networking link in the left menu bar to access the page shown in
Networking Page
FIG. 16
Networking Page Options
TABLE 7
Option
N7142 Network: These settings apply to the N7142 Room Switcher.
MAC Address
Network Mode
IP Address
Netmask
Gateway Address
Internal Switch: These setting apply to the N7142's built-in, six-port switch.
MAC Address
Network Mode
IP Address
Netmask
Gateway Address
N7142 User Manual
Description
Displays the MAC address of the network interface.
Configure the IP address mode. When set to AUTO IP, an IP Address in the range of 169.254.xxx.xxx with
Netmask of 255.255.0.0 and Gateway address of 169.254.1.1 will be automatically assigned to the N7142
Room Switcher by the control software. When set to DHCP, an IP Address in the range of the DHCP server on the
network will be automatically assigned to the N7142 Room Switcher. When set to STATIC, an IP address,
Netmask, and Gateway address must be manually entered.
NOTE:
DHCP is the default setting. However, using DHCP beyond initial setup is generally not recommended. If the
device is set to DHCP and fails to receive an address from the DHCP server in time, it will revert back to the AUTO
IP address (169.254.xxx.xxx) until the unit is rebooted.
View the current IP address. When in STATIC mode, enter a new IP address into this field.
View the current Netmask. When in STATIC mode, enter a new Netmask into this field.
View the current Gateway address. When in STATIC mode, enter a new Gateway address into this field.
Displays the MAC address of the internal switch.
Configure the IP address mode. Only STATIC and DHCP modes are supported. See the N7142's Network Mode
setting description earlier in this table for more considerations. To log in to the internal switch's configuration
menus, enter its IP address into your browser. When prompted, enter the username and password. The default
username is admin with no password.
View the current IP address. When in STATIC mode, enter a new IP address into this field.
View the current Netmask. When in STATIC mode, enter a new Netmask into this field.
View the current Gateway address. When in STATIC mode, enter a new Gateway address into this field.
Room Switcher Configuration Options
Figure
16. See
Table 7
for option descriptions.
19
Advertisement
Table of Contents
