Disassemble The Temperature Module - Welch Allyn 53000 Service Manual

Service manual

Disassemble the temperature module

Note
1. Remove the temperature module from the monitor.
a. Remove the two screws (located on the left side, inside the rear chassis) securing
b. Separate the temperature module from the rear chassis and pull the temperature
Disassembly of the temperature module does NOT require removal of the main
board.
the module to the slots on the left side of the rear chassis. To prevent the module
from dropping, hold it as you remove the screws.
Temperature cable
two screws securing the
temperature module
cable through the slot in the rear chassis.
Disassembly procedure 79