Interacoustics Titan IMP440 Setup & Installation page 48

4. Wait while the Wizard searches for your device. Select the Titan and click Next.
5. Select Use the passkey found in the documentation and enter 1234. Click Next. The Titan and
your PC are now connected via Bluetooth. Click Finish.
To confirm the Bluetooth pairing, Start up the Titan Suite from Otoaccess, Noah or in Standalone mode (see
the Operation Manaul for further instruction). Ensure that the Titan is still switched on.
6. Allow the Bluetooth device to search for the Titan. After a short while, your Titan with corresponding
identification number will appear in the window below.
may need to uninstall this and then try re-pairing the Titan with your PC.
Titan
7. Click on "Titan xxxxxx" and wait a few seconds to
8. On connection, the Suite will finish launching and
Now the Titan can be operated from PC in the same way as
if it was connected via a USB cable.
Note: If the Titan will not connect correctly and your PC
has its manufacturer's Bluetooth Driver installed, you
Setup and Installation Manual
allow it to connect.
the Titan HHU screen will show "PC-controlled"
Page 44