Table of Contents
Advertisement
Take the cleaning tool apart to find the thin brush and thin
rigid plastic cord.
Use the plastic cord or brush to remove any debris from the
probe tip. Always insert the cleaning tool from the rear to
avoid accumulation of debris inside the small round vents.
Place the probe tip back onto the probe. Make sure that the
holes fit into the corresponding cavities.
Screw the probe cap back onto the probe. Finger force will
tighten the screw sufficiently. Never use tools to affix the
probe cap!
If any blockage or damage occurs to the sealing gasket, the
probe system can only be serviced by Interacoustics.
Titan
Setup and Installation Manual
Page 30
Hide quick links:
Advertisement
Table of Contents
