Standalone Use Of Titan Suite; License; Pc Controlled Measurements With Use Of Bluetooth Connection; Selection Of Transducers - Interacoustics Titan IMP440 Setup & Installation

If you are using HIMSA's Noah 3 Office System and you want a shortcut icon for the installed module, please
follow these steps.
Start NOAH3, go to the menu item Tools | Module buttons. Select one of the two available icons and select
the Titan Suite software name from the drop down list. Press Ok and your module will be launched when the
appropriate icon is clicked.
2.2.3.5

Standalone Use of Titan Suite

If you do not want to run the Titan Suite through NOAH or OtoAccess™ you can make a shortcut on the
desktop to directly launch the Titan Suite as a standalone module.
Go to Start | Programs | Interacoustics | Titan Suite. Right click on Titan Suite and select Send To | Desktop
(create shortcut). A shortcut for the Titan Suite will now appear on your desktop.
Note: Saving sessions in standalone mode will not link the measurements to a specific patient and cannot be
transferred to a patient in the database later.
2.2.3.6

License

When you receive the Titan product it already contains the license including the software modules you have
ordered. If you would like to add another module that is available in the Titan Suite, please contact your
dealer for a license.
2.2.3.7

PC controlled Measurements with use of Bluetooth connection

If you want to use a Bluetooth connection to carry out PC controlled measurements with the Titan, you have
to assure that Bluetooth is installed on your PC. If Windows asks for a passkey during the installation
process:
The default passkey is 1234.
For further information about setting up a Bluetooth connection, please refer to the Bluetooth Installation
Quick Guides for Windows XP and Windows 7 at the end of the manual.
2.2.4

Selection of transducers

Titan operates with different transducers. The table below shows which transducers are available for use
with the Titan.
Module
Impedance
DPOAE
ABRIS
The shoulder box (used with IMP440/DPOAE440) contains calibration data for only one contra phone. The
specific contra phone is calibrated with the shoulder box and cannot be swapped over to another transducer
without changing the calibration data in the shoulder box.
The PreAmp detects which ID transducer is connected to it and will automatically read the calibration data
from the ID transducer. The PreAmp allows you to change from one ID transducer to another at any time as
they use the special Omnetics plug.
Titan
Available transducers
Titan probe
Titan probe
Titan probe
ID EARTone ABR 50Ohm (binaural inserts)
ID TDH39 (binaural headphones)
ID DD45 (binaural headphones)
Setup and Installation Manual
Contra phone
(acoustic reflexes only)
CIR55 (insert)
EARTone3A (single insert)
TDH39 (single headphone)
DD45 (single headphone)
-
-
Page 26