Installation Of The Driver; Installation Of Noah Toolbar Shortcut - Interacoustics Titan IMP440 Setup & Installation

2.2.3.3

Installation of the Driver

Now that the Titan Suite software is installed, you must install the driver for the Titan.
For Windows 7:
1. Connect the Titan via a USB connection (directly or via the cradle) to the PC. Turn the Titan on by
pressing down either the R or L button on the handheld unit.
2. The system will automatically detect the new hardware and a pop-up will appear on the task bar near
the clock indicating that the driver is installed and the hardware is ready to use.
For Windows XP:
1. Connect the Titan via a USB connection (directly or via the cradle) to the PC. Turn the Titan on by
pressing down either the R or L button on the handheld unit.
2. A pop-up indicating "New Hardware Found" will appear near the clock on the Start bar.
3. Wait for the dialog shown below to appear. Select "No, not this time" and click Next.
4. On the next screen, select "Install the software automatically (Recommended)" and click Next. When
the driver has finished installing, click Finish to close the wizard.
Titan Setup and Installation Manual
2.2.3.4 Installation of NOAH Toolbar
shortcut
Page 25