Table of Contents
Advertisement
Planning the use
3.7 Planning the installation location and clearance of the docking station
3.7
Planning the installation location and clearance of the docking
station
Selecting the mounting location
The docking station is designed for vertical installation.
WARNING
Installing the docking station
When the HMI device is operated in the plant and docking station is mounted, the
EMERGENCY STOP button must be enabled. The EMERGENCY STOP button is not
enabled when the docking station is in a plant area with insufficient wireless coverage.
The docking station must be installed in either a plant section with sufficiently wide WLAN
coverage or a separate service area.
CAUTION
Stopping the plant
The HMI device can fall down if it is not securely hooked in. This can accidentally trigger
the EMERGENCY STOP button.
Install the docking station on a vertical surface or one that is slightly inclined towards the
back.
The location of the docking station must be free of vibrations.
If the docking station vibrates while the HMI device is resting in it, the HMI device may
come off.
Find a location without vibration for installation of the docking station. For additional
information, see Section Operating conditions (Page 48).
NOTICE
Charging the rechargeable battery
When charging a rechargeable battery, the ambient temperature or battery temperature
should not exceed 40 °C. The higher the temperature, the longer it will take for the
rechargeable battery to fully charge.
Find a place with a cool ambient temperature for the docking station.
Select a location with the following characteristics for installing the docking station:
● Easily and safely accessible
● No exposure to direct sunlight
● It is easy to hook in and remove the HMI device in the docking station
● Ergonomic operation of the HMI device in the docking station is ensured
56
PRELIMINARY II
Wireless Teach Pendant F IWLAN V2
Operating Instructions, 08/2010, A5E02453837-01
1.7.2010
Advertisement
Table of Contents
