Siemens F IWLAN Operating Instructions Manual page 43

Hmi device wireless teach pendant v2

Table of Contents

The Stop category of the enabling device must be selected on the basis of a risk assessment

and correspond to a Category 0 or 1 Stop.

WARNING

Injury or material damage

Enabling buttons should only be used when the following applies for the person activating

the enabling button:

 The person can see the danger zone.

 The person is capable of recognizing personal injury hazards in good time.

 The person is capable of taking immediate measures to avoid danger.

The only person allowed to remain in the danger zone is the person who is activating the

enabling button.

Commands for unsafe conditions are not permitted to be issued with one enabling button

alone. To accomplish this, a secondary, conscious start command using a button on the

HMI device is required.

NOTICE

Risk from improper use

An enabling button can be fixed without permission.

To avoid the risk of unauthorized fixation, fully press both enabling buttons each time the

project starts. Release the enabling buttons.

Note

The enabling button only has an effect when the HMI device is logged onto a machine and

the "RNG" LED on the HMI device is lit.

Simatic hmi