Connecting The Base Station - Siemens Gigaset C355 Manual

Handset at a glance
Base unit at a glance
7
You can use the keys on the base unit to
operate the built-in answering machine
and register handsets to the base.
1 Registration/paging key
Page handsets (press briefly, "Paging",
page 32).
Register handsets and DECT devices
(press and hold, page 31).
2 On/Off key: Activate/deactivate answering
machine.
Lights up: The answering machine is acti-
vated.
Flashes: There is at least one new message.
During message playback:
3 Delete the current message.
4 Go to the next (press once) or next-but-one
(press twice) message.
5 Playback/Stop Key:
Play back messages from the answering
machine, or cancel playback (press briefly).
Play back new and old messages one after
the other (press and hold).
6 Adjust volume during message:
ð ñ
= quieter; = louder.
While an incoming call is being indicated:
Adjust ringer volume.
7 Go to the start of the message (press once)
or to the previous message (press twice).
Please note:
u
The answering machine cannot be
operated from the base while it is being
operated from a handset or recording a
message.
u
If the On/Off key flashes although the
answering machine is switched off, it
means that there is still at least one
new message that has not been played
back yet.
2

Connecting the base station

¤
1
Please connect the mains unit first and
2
then connect the phone jack as shown
3
below, placing the cords in the cord
recesses.
4
5
6
1
1
1 Underside of the base unit (partial view)
2 230 V mains unit
3 Phone jack with phone cord
Please note:
u
The mains units must be plugged in at
all times as the phone will not work
without a mains connection.
u
If you buy a replacement phone cord in
the shops make sure that the phone
jack has the correct type of wiring.
Correct phone jack wiring
3
2
1
2
3
1
1
1 unused
4
2 unused
5
3 a
6
4 b
5 unused
6 unused