Table of Contents
Advertisement
Mounting and connection
4.5 Connecting the HMI device
Procedure – Disconnecting the charger
Proceed as follows:
1. Pull the plug of the power cable out of the charger's socket.
The "POWER" LED goes out.
2. Disconnect the power supply from the mains.
4.5.6.4
Showing the battery charge
The main rechargeable battery features an LED array. The respective LEDs indicate the
battery charge.
Requirement
● The main rechargeable battery is removed from the HMI device.
Procedure
Proceed as follows:
1. Press the button.
The LED lights when the button is released after approx. 5 seconds.
The number of illuminated LEDs indicates the charge status.
Number of LEDs
If all the LEDs light up, the main rechargeable battery is fully charged.
Note
This applies to rechargeable batteries that are stored – read the section "Maintenance and
care (Page 237)".
76
Flashes for
1
0 to 19 % of the charge capacity
2
-
3
-
4
-
5
-
PRELIMINARY II
Lights for
20 to 39 % of the charge capacity
40 to 59 % of the charge capacity
60 to 79 % of the charge capacity
80 to 96 % of the charge capacity
97 to 100 % of the charge capacity
Wireless Teach Pendant F IWLAN V2
Operating Instructions, 08/2010, A5E02453837-01
1.7.2010
Advertisement
Table of Contents
